Skip to main content

Monitor settings for Mindray VS9 if using Mindray DIAP cable

Not relevant if using Xlink

Written by Henrik Joreteg

Tap upper left corner and make sure it it set to "Continuous Profile"
​

Navigate to:
​

  1. Main Menu

  2. Maintenance

  3. Password: MIN888

  4. Use << and >> symbols in upper right corner to find and select Other tab

  5. Click Paremeter Output Setup set the following:

    1. Baud Rate: 38400

    2. Parity Mode: None

    3. Data Bits: 8

    4. Stop Bits: 1

Parameter Outpue Setup should look like this:


​Connect it physically as follows:

Did this answer your question?